:	Jun 30, 2004

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

: Since injury such as scalding could be caused by escaping steam or coolant, do not remove the filler cap from the coolant expansion tank while the system is hot. Drain the cooling system.

.

Remove the accessory drive belt.

.

Remove the bolt from the power steering pipe clip.   Position the pipe aside when removing the coolant pump.

.

Remove the coolant pump.   Disconnect the coolant rail hose from the coolant pump.   Remove the 12 bolts.   Discard the gasket.

.

:   Do not disassemble further if the component is removed for access only. Remove the coolant pump drive pulley.   Remove and discard the 4 bolts.   Remove the coolant pump capping hose.

.

To install, reverse the removal procedure.   Install the coolant pump pulley.   Clean the component mating faces.   Install a new gasket.

.

Tighten the coolant pump retaining bolts.   Tighten to 10 Nm (7 lb.ft).

.

Tighten the coolant pump pulley retaining bolts.   Tighten to 25 Nm (18 lb.ft).

.

Install the power steering pipe.   Tighten the bolt to 10 Nm (7 lb.ft).

.

Install the accessory drive belt.

.

Refill the cooling system.

.

Connect the battery ground cable.